JCB — 17.pdf (p.17)

Section C - Electrics Basic System Operation Slew Brake (100%) Slew Brake (100%) Operation C028410GB-2 Fig 61. The slew parking brake holds the current slew position of the machine and prevents slew drift. If however the upper pilot pressure switch remains de- activated for 5 seconds or longer, the slew brake solenoid will de-energise (brake on). The slew brake solenoid will remain de-energised until the slew pilot pressure switch is activated. This is the default operation with the engine running. The operator signals for slew movement by moving the left hand joystick. This results in the slew pilot pressure switch being activated.

This signals the ECU1 to energise the slew parking brake solenoid valve, thus enabling slew. When L mode (lifting) is selected, the upper pilot pressure switch is ignored and 100% brake applied. When the slew pilot switch is energised the slew parking brake is lifted. The slew pilot pressure switch is de-activated, by returning the joysticks to neutral, and the upper structure comes to a stop using a hydrostatic brake (cross lines relief valve). If this condition exists for 5 seconds then the slew parking brake solenoid is de-energised. Thus applying the slew brake. By Default Slew parking brake is automatically applied at start up.

To prevent any damage to the slew brake occurring when excavating the slew brake solenoid will remain energised and the slew brake remain off, if the upper pilot pressure switch is activated or re-activated within 5 seconds of the slew pressure switch closing. C-60 C-60 9803/9880-3