JCB — 44.pdf (p.44)

Section 3 - Maintenance Routine Maintenance Electrical System Jump-Starting the Engine a Open the side panel to gain access to the batteries. !M WARNING b Connect the positive booster cable to the positive (+) terminal on the front battery of the machine A . In temperatures below freezing, the battery electrolyte may freeze if the battery is discharged or poorly charged. Do not use a battery if its electrolyte is frozen. To prevent the battery electrolyte from freezing, keep the battery at full charge. c Connect the other end of this cable to the positive (+) terminal of the booster supply B . If you try to charge a frozen battery or jump-start and run the engine, the battery could explode.

d Connect the negative (-) booster cable to a clean metal part of the machine C away from and below the battery. Batteries produce a flammable gas, which is explosive; do not smoke when checking the electrolyte levels. Note: The connection on the machine must be free from paint and dirt. Do not use a pivot pin for an earth. e Connect the other end of this cable to the negative (-) terminal on the booster supply. When jump-starting from another vehicle, make sure that the two vehicles do not touch each other. This prevents any chance of sparks near the battery. 3 Do the Pre-Start Checks. Switch off all circuits which are not controlled by the starter switch. 4 Start the Engine.

Run the machine on Redundancy mode for ten minutes before switching to computer mode. Do not connect the booster (slave) supply directly across the starter motor. 5 Disconnect the Booster Cables. Use only sound jump leads with securely attached connectors. Connect one jump lead at a time. a Disconnect the negative (-) booster cable from the machine frame earth. Then disconnect it from the booster supply. The machine has a negative earth electrical system. Check which battery terminal is positive (+) before making any connections.

Keep metal watch straps and jewellery away from the jump lead connectors and the battery terminals - an accidental short could cause serious burns and damage equipment. Make sure you know the voltage of the machine. The booster (slave) supply must not be higher than that of the machine. Using a higher voltage supply will damage your machine's electrical system. If you do not know the voltage of your booster (slave) supply, then contact your JCB dealer for advice. Do not attempt to jump- start the engine until you are sure of the voltage of the booster (slave) supply. b Disconnect the positive (+) booster cable from the positive (+) terminal on the battery.

Then disconnect it from the booster supply. 8-2-7-4 1 Set all Switches in the Cab to OFF. 2 Connect the Booster Cables as follows: Note: These machines have 2 batteries which are connected in series to give 24 volts. Use a booster supply of 24 volts. Fig 21. 3-44 3-44 9803/JSM-0412