JCB — 84.pdf (p.84)

Section B - Body and Framework Service Procedures HVAC/Air Conditioning Unit TB-009 Removal Note: Before removing the HVAC/Air Conditioning Unit, the system must be discharged. A !M WARNING B The air conditioning system is a closed loop system and contains pressurised refrigerant. No part of the system should be disconnected until the system has been discharged by a refrigeration engineer or a suitably trained person. You can be severely frostbitten or injured by escaping refrigerant. 4-3-4-1_2 A !M CAUTION Do not operate the air conditioning system when there is no refrigerant in the system, otherwise the compressor will be damaged.

4-3-4-4 !M WARNING Do not carry out welding operations close to the air conditioning refrigerant circuit. A poisonous gas is produced when refrigerant comes into contact with naked flames. Do not smoke or allow naked flames close to the refrigerant circuit. D C C030670-C2 Fig 8. BF-1-9 The heater and air conditioning units are built into the same module, enabling the units to be interchanged as complete assemblies. 2 Remove the fixing screws A and lift off the rear panel B . 3 Disconnect the harness C from the heater unit by releasing the cable ties. Disconnect the heater assembly plug D . 1 Working in the cab, remove the drivers seat from its runners to provide access to the heater unit.

B-23 B-23 9803/9880-3