honda — BF75A/BF90A

6. BF75NBF90A REMOTE CONTROL CABLE INSTALLATION AND ADJUSTMENT Route and connect cables to the remote control before connecting them to the motor. CONTROL CABLE THROTTLE PIVOT SHAFT SHIFT CABLE CONNECTOR minimum .(J 3. Thread pivot shaft onto threaded portion of the throttle and shift cable as shown. 4. Do not tighten lock nuts at this time. The lock nuts will be tightened after cables are connected. 3 mm (0.12 in) '/ \ 'HARNESS GROMMET TIE-WRAP BAND 1. Pass wire harness and control cables through grommet. Hold control cables with cable clamp plate by aligning the plate cutout with cable groove. Position tie-wrap band on wire harness inside grommet as shown.

SELF-TAPPING BOLT, 6 x 28 mm (2) S C CABLE CLAMP PLATE 5. Pull and hold throttle arm against throttle arm stop. + 1 mm (0.04 in) I ROLLER \ HEX. Check clearance between carburetor throttle lever and throttle lever stop. Wide open throttle (WOT) clearance should be 1 mm (0.04 in) or less. If adjustment is necessary, refer to the Honda Marine BF75N90A Shop Manual (page 3-12 through 3-15) for open and close cable adjustment. If clearance is within specifications, release throttle arm and proceed to step 6. I I 2. Install separate cover and tighten bolts securely. TORQUE: Self-tapping bolt, 6 x 28 mm: 12 N*m (9 ft-lb) Hex bolt, 6 x 35 mm: 10 N*m (7 ft-lb) Date of Issue:

June 2003 0 2001-2003 American Honda Motor Co., Inc. 6-1 1