2. BF8DIBF9.9D 3/8-24 UNF SELF- LOCKING NUT (2) 118 N-rn (1.8 kgf-rn, 13 Ib-ft) I STEERING PLATE SELF-LOCKING NUT (see step 7 below) / 3/8-24 UNF BOLT 4. Install the steering link rod between the steering plate on the motor side and ., ,e cable end using the bolt, washers, nuts, and collar as shown. 5. Connect the steering link rod to the inside hole of the steering plate. Do not mount anything in the outer hole of the steering plate. 6. When connecting the link rod with the cable end, turn the outboard motor and steering wheel to the port side. Apply marine grease to the collar and sliding position of the link rod as shown before installation. 7.
Turn steering wheel to retract steering cable into the steering/tilt tube. Tighten self-locking nut, then loosen self-locking nut 118 turn. TORQUE: 8-11 N-m (7-8 ft-lb) 8. After attaching the cable, turn the steering wheel to the right and left, checking the steering angle. If necessary, adjust at the steering cable side, until both angles are even. Support Type STEERING ' PLATE STEERING GUIDE CABLE \ OUTER HOLE Insert the steering cable into the outer hole of the steering plate and fasten with a nut. 219 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.