honda — BF8D/BF9.9D

2. BF8DIBF9.9D BOLTING MOTOR TO TRANSOM 10 mm SELF-LOCKING NUT (4) I WASHER 18) / n \ \ BOAT Apply marine hull sealant to the mounting holes and hardware. Use Hondabond equivalent silicone sealant for below waterline use. With the motor in place against the transom, verify correct motor height. Motor can be raised by using a lower set of mounting holes. Attach the motor with marine grade hardware. Use washers under all bolts and nuts. Use additional fender washers against the transom. Use support plates as recommended by the hull manufacturer. Apply a small amount of oil or grease to all bolt threads prior to installation.

Be sure at least one thread of the bolt is visible beyond the nut when the fasteners are tightened. I NOTICE I Do not use an air impact tool to tighten or loosen the transom bolts. Using an air impact tool to tighten or loosen the transom bolts can generate enough heat to damage the bolt threads. The air impact tool can also produce enough tightening torque to damage the boat transom. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 2 4 0