Data N38143 Pipe size: • Supply - Outside diameter......................................... 7.9mm (0.315”) • Supply - Bore............................................................ 6.53mm (0.257”) • Return - Outside diameter.......................................... 6.3mm (0.25”) • Return - Bore............................................................ 4.93mm (0.194”) Maximum lift pump lift..............................1.8m (6 ft) to bottom of tank suction pipe.
Maximum fuel lift pump depression at inlet...................127mm (5”) Hg Fuel consumption at full power......24.6 l/hr (6.5 US galls/hr) ........27.7 l/hr (7.3 US galls/hr) Air Intake Combustion airflow..........................7.9m 3 /min (279 ft 3 /min)........... 9.9m 3 /min (350 ft 3 /min) Maximum engine compartment air temperature............60 O C (140 O F) Maximum air temperature at engine inlet.......................52 O C (126 O F) Ventilation - maximum engine room depression.....125mm H 2 O (5 in H 2 O) Suggested ventilation airflow including combustion air.........................................
31m 3 /min (1095 ft 3 /min) Minimum cross section of air duct (per engine)....................................461 cm 2 (71.5 sq ins) for hot climates. ...........................................................231 cm 2 (35.8 sq ins) for temperate climates. Exhaust Exhaust gas flow............................19.5m 3 /min (689 ft 3 /min)......... 24.3m 3 /min (858 ft 3 /min) Maximum restriction measured within(305 mm) 12” outlet.............................................15kPa (4.4” Hg) Recommended pipe bore (wet exhaust)........................100mm (4.0”) Recommended pipe bore (dry).....................................
76.2mm (3.0”) Minimum rise from sea water level to exhaust outlet centreline................................................203mm (8.0”) Lubricating System Recommended lubricating oil..................................AP1 CD/SE CCMC D4 Sump capacity maximum........................................15 litres (4 US gallons) Normal operating angles...............................25 O from horizontal in any direction Oil pressure, in operating speed range (steady state).......................................... 250kPa (36 psi) Low oil pressure switch setting.....................................
83kPa (12 psi) Electrical System Generator................................................................100A (12V), 55A (24V) Starter type........................................................................12V, 4 kW Number of teeth in flywheel....................................................126 Number of teeth on starter......................................................10 Cold Start Limits Minimum cold start temperature (with aid)...................... -15 O C (5 O F) Batteries for min cold start......................................1 x 12V, 660 amp SAE Page 84