Safety - Section 20 2/13 OM2049 Page 20-14 Warnings And Cautions All applicable local mine, government, and industry rules for working with high voltage must be followed. Required personal protective equipment, including but not limited to safety shoes, high voltage gloves, and safety glasses must be worn. Hazardous voltages are present in this equip- ment. Avoid touching any energized equipment when the door to the low voltage area is open. Safety cautions and warnings appear throughout the instructions. WARNING indicates the potential for personal injury and CAUTION indicates the potential for equipment damage. Read the following warnings prior to working on this drive system.
Failure to do so may result in personal injury and equipment damage. Hazardous voltages are present in this equip- ment. Ensure that the Control Power Switch (CPS) is in the OFF position and that the Genera- tor Field Contactor (GFCO) switch is in the CUT- OUT position before attempting any work on the drive system components. Check that Capacitor Charge Lights (CCL’s) are not illuminated. Hazardous voltages may be present in this equip- ment even if the engine and capacitor charge lights are off. Use measurement and protective equipment rated for 2000 VDC minimum to verify that no voltage is present before touching any terminal.
Use measurement and protective equipment rated for 2000 VDC minimum to verify that no voltage is present before touching any terminal. Verify functionality of the measurement equip- ment using site-approved procedures both before and after performing control group mea- surements. Verify functionality of the measurement equip- ment using site-approved procedures both before and after performing control group mea- surements. Failure to observe these precautions may result in death or serious personal injury. Failure to observe these precautions may result in death or serious personal injury. Voltages in excess of 1500 VDC may be present.
Any measurement and/or protective equipment used must be rated at 2000 VDC minimum. Verify that the Capacitor Charge Light (CCL) above the high voltage contactor area is not illu- minated before opening the doors to the high voltage area or the high voltage contactor area. Verify functionality of the measurement equip- ment using site-approved procedures both before and after performing control group mea- surements. Use measurement and protective equipment rated for 2000 VDC minimum to verify that no voltage is present before touching any terminal. Failure to observe these precautions may result in death or serious personal injury.
Verify functionality of the measurement equip- ment using site-approved procedures both before and after performing control group mea- surements. Failure to observe these precautions may result in death or serious personal injury.