hyundai R60WVS Pro — 7. AXLE

Install the nut (1) without loctite 270. 17 18 Lock the wrench T6, rotate the pinion using a dynamometric wrench, up to a minimum required torque setting of 26.5~30.6 kgf · m (192~221 lbf · ft ). 19 Apply onto the pinion (1) the bar-hold and with the help of a torque meter, check the torque of the pinion (1). · Torque : 0.08~0.12 kgf · m (0.58~0.87 lbf · ft ) If torque exceeds the maximum value, then the size of shim “S1” (4) between the bearing (9) and the distance piece (3) needs to be increased. If torque does not reach the set value, increase the torque setting of the ring nut (10) in different stages to obtain a maximum value of 51 kgf · m (369 lbf · ft ).

If torque does not reach the minimum value, then the size of shim “S1” (4) needs to be reduced. When calculating the increase or decrease in size of shim “S1”, bear in mind that a variation of shim of 0.01 mm corresponds to a variation of 0.06 kgf · m (0.44 lbf · ft ) in the torque of the pinion (1). 7-236