hyundai R60WVS Pro — 11. WORK EQUIPMENT

2) 2) ARM ASSEMBLY ARM ASSEMBLY (1) (1) Removal Removal Loosen the breather slowly to release the pressure inside the hydraulic tank. Escaping fluid under pressure can Escaping fluid under pressure can penetrated the skin causing serious penetrated the skin causing serious injury. injury. ① Remove bucket assembly. For details, see removal of bucket assembly. Disconnect bucket cylinder hose (4). ② Fit blind plugs (5) in the piping at the Fit blind plugs (5) in the piping at the chassis end securely to prevent oil chassis end securely to prevent oil from spurting out when the engine is from spurting out when the engine is started. started.

4 5 ③ Sling arm cylinder assembly, remove spring, pin stopper and pull out pin. Tie the rod with wire to prevent it from coming out. 4 ④ For details, see removal of arm cylinder assembly. Place a wooden block under the cylinder and bring the cylinder down to it. Remove bolt (1) and pull out the pin (2) then remove the arm assembly. · Weight : 210 kg (470 lb ) When lifting the arm assembly, always lift the center of gravity. ⑤ 1,2 (2) (2) ① Install Install Carry out installation in the reverse order to removal. When lifting the arm assembly, always lift the center of gravity. Bleed the air from the cylinder. 7-278