Komatsu — ADJUSTMENT OF VALVE CLEARANCE

TESTING AND ADJUSTMENTS ADJUSTMENT OF VALVE CLEARANCE ADJUSTMENT OF VALVE CLEARANCE # Adjust the clearance between valve and rockers to the following values: Unit: mm 1 - Remove the intake filter and the valve cover. 1 2 - Turn the drive shaft in the normal direction of rotation until the line (1) marked as no. 1 on the flywheel is in ali- gnment with the reference notch (2) on the flywheel housing. # If the cylinder is in a compression stroke, the valves do not move when the drive shaft is rotated slightly. If the valves do move, rotate the drive shaft by one turn and realign the reference marks (1) and (2).

RKS 01670 6 4 3 - Loosen the lock nut (3) and unscrew the adjustment screw (4) by approximately 1 turn. # Check that the valve cap (5) is lying flat on the valve stem and that there is no lop-sided wear. 1 - If the valve caps (5) are damaged, replace them with new ones. 2 - Make sure that the valve caps fit perfectly and are lying flat on the valve stem. 3 5 YES NO 5 RKS 01681 4 - Insert the feeler gauge B1 between the rocker (6) and the valve cap (5). Rotate the adjusting screw (4) until it rubs against the fe- eler gauge B1 . Secure this position with the nut (3). Lock nut: 25.5 2.5 Nm # After locking the nut (3), check the valve clearance again. B 1 5 - After adjusting the No.

1 cylinder, rotate the drive shaft 180° each time and adjust the valve clearance of the other cylinders according to the ignition sequence. # Ignition sequence: 1 - 3 - 4 - 2. RKSA0030 Assembly of the valve cover 10 9 8 1 - Check the condition of the gasket (7) of the valve cover (8), and the O-rings (9). Thoroughly clean the contact surface on the cylinder heads. 2 - Replace the valve cover (8) and mount the O-rings (9) and the lock nuts (10). Lock nuts for cover: 25 3 Nm 7 RKS01200 20-16 SK714-5 SK815-5 With engine cold Suction valves Exhaust valves 0.20 0.20