TESTING AND ADJUSTMENTS MEASUREMENT OF THE COMPRESSION PRESSURE MEASUREMENT OF THE COMPRESSION PRESSURE While measuring the compression, take care not to get entangled in the cooling fan, the alternator belt, or in other rotating parts. Check all cylinders. # Test conditions: Engine: at working temperature. Olio idraulico: 45 55°C. Battery: fully charged. Valve clearance: adjusted (See «ADJUSTMENT OF VALVE CLEARAN- CE»). 1 2 1 - Remove air filter with support. RKSA0040 2 - Disconnect the high-pressure tube (1). 3 - Remove the nozzle holder (2) of the cylinder to be che- cked. 4 4 - Disconnect the connector(3)of the engine-stopping so- lenoid and close the fuel cock (4).
3 5 - Turn the engine over a few times, using the starting mo- tor. RKSA0050 6 - Mount the adapter C2 and connect the test pressure gauge C1 . # Check that the seal is mounted in the adapter, and that it is undamaged. C 1 7 - Turn the engine using the starting motor and read the compression value. # Read the compression value when the pressure gauge has stabilised. # While reading the compression, also check the en- gine rpm using the tachometer A1 or A2 . If the spe- ed does not correspond with the control value, check it against the diagram. # Compression value: Normal: 35 1 kg/cmІ at 250 rpm Minimum permissible: 26 1 kg/cmІ at 250 rpm # Maximum difference between the cylinders:
2 3 kg/cmІ C 2 RKSA0060 Compression pressure (kg/cm 2 ) 40 8 - After the reading, re-assemble the nozzle holder (2), and reconnect the high- pressure tube (1) and the con- nector (3). 35 30 Nut that secures the nozzle: 7.84 0.98 Nm 25 High-pressure coupling: 31.85 2.45 Nm 20 200 250 300 350 400 Engine speed (giri/min) RKS 01511 20-17 SK714-5 SK815-5