REMOVAL AND INSTALLATION WHEEL HUB 8 - Place the hub (1) in a vice and extract the seal ring (9). # Mount a new seal ring (9) each time the hub is di- smantled. 1 9 4 7 8 RKSA0800 9 - Extract the outer rings (7) and (8). x 5 ASSEMBLY OF THE HUB WHEEL 6 To install, reverse removal procedure. 1 RKSA0810 Screw: 294 Nm 2 1 - Take the existing measurement between the axle shaft (6) and the ring bevel gear (5). 2 - Calculate the thickness of shim that should be inserted between the disc (3) and the ring bevel gear (5) using the following formula: Z = X S S = the shim pack X = the measurement taken Z = residual clearance (0.05 0.125) For example :
clearance measured X = 0.570 Addition of two shims of 0.2 and one of 0.1 3 - Check that the measurement X lies within the permis- sible limits. 3 # Grease the bearings (7) and (8). Bearings: Litio EP NLGI 2 4 # Grease the lip of the seal ring (9). Seal ring: Litio EP NLGI 2 30-38 SK714-5 SK815-5