daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

3) Valve seat Contacting face amount Measure the contacting face between the intake valve seat and exhaust valve seat for valve seat wear, and replace if the measured value exceeds the speci- fied limit. Install the valve into the valve seat on the cylinder head, and check the amount of depression of the valve from the lower portion of the cylinder head using a dial gauge. Valve depression If the amount of depression is beyond the specified limit, replace the valve seat. For removal of the valve seat, apply arc welding work to two points of valve seat insert, and pull out the valve seat insert Valve seat insert with inner extractor.

Cylinder head Welding bead EA3M2032 Undercool a new valve seat with dry ice for about 2 hours and press the valve head using a special tool (bench press). Apply valve lapping compound to the seat insert into position in the cylinder valve head seating face on the valve seat and lap the valve seat by turning it until it is seated in position, then wipe out the lapping compound. - 44 - EA0M4046 EA0M4046 Standard Limit Intake & Exhaust 0 ~ 0.3 mm 0.55 mm