daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

4) Valve spring Visual check Visually check the exterior of the valve springs for damage, and replace if nec- essary. Functional check - Measure free length and spring tension with a valve spring tester. (Refer to appendix) - Measure the spring inclination with a square. - Compare the measured value with the standard value to determine whether to replace or repair. 3.2.4. Rocker arm shaft assembly 1) Rocker arm shaft Rocker arm shaft run-out Place the rocker arm shaft on two V blocks and inspect the shaft for bend using a dial gauge. If the amount of this run-out is small, press the shaft with a bench press to correct the run-out Replace the shaft if the measured value exceeds the limit.

EDM2037I - 45 - 1.0mm or less length Free EFM2039I Standard Limit Valve spring inclination 1.0 mm 2.0 mm Limit 0.2 mm