- 46 - Rocker arm shaft diameter With an outside micrometer, measure the rocker arm shaft diameter at the point where the rocker arms have been installed. Replace the rocker arm if the amount of wear is beyond the specified limit. Standard Limit EA8M3002 23.978 ~ 23.959 mm 23.75 mm Rocker arm Visual check Visually check the face of the rocker arm in contact with the valve stem end for scores and step wear. If the wear is small, correct it with an oil stone or grind- ing paper of fine grain size. Rocker arm with a considerable amount of step wear should be replaced.
Diameter of the rocker arm bushing Measure the inside diameter of the rock- er arm bushing with an inside microme- ter or vernier calipers, and compare the measured values with the rocker arm shaft diameter. If the clearance exceeds the limit, replace either bushing or shaft, whichever worn more. EA0M4059 Standard Limit 0.020 ~ 0.093 mm 0.2 mm Tappet and push rod Clearance Measure the clearance of the tappet and tappet holes of the cylinder block. If the value is beyond the specified limit, replace tappets. Standard Limit 0.035 ~ 0.077 mm 0.15 mm EA8M3002 EA8M3002 Standard Limit 0.035 ~ 0.077 mm 0.15 mm Standard Limit 23.978 ~ 23.959 mm 23.75 mm Standard Limit 0.020 ~ 0.093 mm 0.2 mm