Visual check of tappet Visually check the face of the tappets in contact with the cam for pitting, scores or cracks, and replace if severely damaged. If the amount of cracks or pitting is small, correct with an oil stone or grinding (1) Unevenness (2) Crack (3) Normal paper. (4) Abnormal EA0M4070 Outside diameter With an outside micrometer, measure the tappet outside diameter If the mea- sured value is beyond the limit, replace tappets. EDM2061I Use a feeler gauge to measure the push rod run-out. Roll the push rod along a smooth flat sur- face as shown in the figure.
EA0M4073 Feeler gauge - 47 - Tappet Dia 19.944 ~ 19.965 mm Standard Limit Tappet Clearance 0.035~0.077mm 0.15mm Push rod run-out Limit 0.3 mm or less