3.2.5. Cam shaft 1) Cam Cam lobe height III III C B B A D A EA0M4062 Camshaft bearing EA0M4063 Replace the bushing if the measured value is beyond the specified limit. - 48 - Standard Limit Cam lobe height (C) Intake 50.50~ 50.70 mm 49.5 mm Exhaust 50.70~ 50.90 mm Cam journal diameter(A,B) 59.86~ 59.8 mm 59.52 mm Use a micrometer to measure the cam lobe height and journal diameter. If the measured number is less than the specified limit, the camshaft must replaced. Cam surface Inspect the cam face for scratch or dam- age. Slight step wear or damage on the cam face may be corrected with oil stone or oiled grinding paper. But, replace if severely damaged.
Cam shaft Clearance between camshaft journal and camshaft bush - With an outside micrometer, measure the camshaft journal diameter. - Measure the inside diameter of the camshaft bushing on the cylinder block using a cylinder bore indicator, and compare the measured value with the camshaft outside diameter to deter- mine the clearance. Standard Limit 0.050 ~ 0.128 mm 0.2 mm Standard Limit 0.050 ~ 0.128 mm 0.2 mm