Check and adjust the amount of back- lash between gears using a feeler gauge. 3.3.12. Timing gear case cover Install dowel pin on the timing gear case. Mount a gasket by aligning the fixing bolt holes with those on the gasket. Align the dowel pin with the cover pin hole, then install the cover with light tap. Tighten the fixing bolts beginning with the oil pan fitting face. 3.3.13. Front oil seal Apply lubricating oil to the outside of the oil seal and timing gear case inside diameter and fit them over the crank- shaft, then assemble the oil seal using an oil seal fitting jig. Oil seal fitting jig 3.3.14. Cylinder liner EAMD086I Stand the cylinder block so that the fly- wheel faces downward.
Thoroughly clean the liner flange fitting surface and bore inside with com- pressed air to prevent the entry of for- eign substances. After the cleaning operation, make the cylinder liner dried up and push it into the cylinder block by hand. Wet the liner inside diameter with engine EAMD087I oil. - 64 - Backlash 0.15 ~ 0.25 mm