3.3.15. Piston and connecting rod Use a piston heater to heat the piston approximately 100 C (212 F ) for 5 min- utes. Align the piston pin hole with the oiled connecting rod small end and press the piston pin (by lightly tapping with a rub- ber hammer) to assemble the connect- ing rod with the piston. EAMD088I Noting the direction of the piston, make the longer side (machined with key groove on the bearing) of the connecting rod big end and the mark of ‘ impressed on the inside of the piston face each other in opposite directions.
On the piston head surface, the longer 106 side of connecting rod big end is in opposite direction from the valve seating EAMD089I surface as well as in the same direction with the narrow margin of combustion chamber. nstall the snap rings and check to see that it is securely assembled. Install the piston ring in the piston using piston ring pliers. - 65 -