3.3.20. Nozzle tube Apply sealant (LOCTITE # 620) to the nozzle tube and place the O-ring over the cylinder head fitting face on the noz- zle tube, then install the nozzle tube in the cylinder head. Install a guider of the nozzle tube insert ass’y (Guider + Expander) the cylinder head, then tighten the nozzle fixing nuts. Guider EAMD098I Apply engine oil to an expander and install it onto the special tool (guider). Tighten the bolts until the expander is Expander forced out of the cylinder head bottom. After mounting the nozzle tube, make a hydraulic test to check for water leaks. EAMD099I 3.3.21. Cylinder head Install the injection nozzle fixing stud bolts and water pipe fixing stud bolts.
Clean the head bolt holes on the cylin- der block with compressed air to remove foreign substances and thoroughly clean the gasket fitting face of the cylin- der block. - 69 - Test pressure 2 kg/cm2