Install head gasket, with ‘TOP’ mark fac- ing upward, on the cylinder block by aligning the holes with dowels. TOP EAMD101I Check the inside of combustion cham- ber for foreign substances, and carefully mount the cylinder head assembly in the block by aligning the dowel pin with the dowel pin hole. Be careful not to dam- age the head gasket. If the dowel pin is not in alignment, lift the cylinder head again and then remount it. Coat the head bolts with engine oil, then tighten them in proper sequence to the specified torque. Coat the push rod with engine oil and insert it into the push rod hole.
- 70 - EAMD10 EAMD10 8 2 3 9 12 13 1 4 11 14 7 6 5 10 EAMD10 Type 1 Type 2 Specification TY 12.9T M14x1.5x153 TY 10.9T M14x1.5x150 Torque 24.5 kg.m 6 kg.m +180°+150°