. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS Ambient temperature Lighting time Above 0 ° C 0 seconds -20 ° C to 0 ° C 20 seconds to 45 seconds below -20 ° C 45 seconds 4. If the preheating monitor does not light up, or it lights up and then goes out to inform that the engine preheating has been completed, turn the key in starting switch (3) to the START position (C) and start the engine. REMARK If the ambient temperature is low, the engine may not start even when the key in the starting switch (3) is kept at the START position for 20 seconds. If this happens, wait for at least 2 minutes, then start again from the beginning. 5.
After the engine starts, release the key in starting switch (3). The key will automatically return to the ON position (B). 6. Even if the engine starts, wait for the engine oil pressure monitor to go out. Do not touch the control levers or control pedal while the engine oil pressure monitor is lighted up. NOTICE If the engine oil pressure monitor does not go out even after 4 to 5 seconds have passed, stop the engine immediately. Check the oil level, check for leakage of oil, and take the necessary action. 3 - 99 3. Turn the key in starting switch (3 ) to ON position ( B). If the ambient temperature is low , the preheating m onitor lights up and automatic preheating is carried out .
Kee p the key in starting switch (3) position the monitor goes out. The time tha t the preheating monito r stays l ighted up depends on the ambient temperature as shown i n the table on the right.