. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE check that there is no dirt or NOTICE dirt from entering the inside of the filter 4 - 54 5. artridg damage t o the filter h older and filter cartridge t o the fi lter holde Do n ot fil l the fi lter ca rtridge Cap (A) i cartridge 6. Whe n installing , tighte n until th e packing surfac e contacts the seal surfac e of t he filter h older, th en tighten it 3/4 of a turn. If th e filter cartridge is tightene d too far, the pac king will be da maged and this wil l lead t o leaka ge of fuel. If the filter cartridge i s too lo ose, fuel will also leak fro m the packing , so always tighten the co rrect a mount 7.
Afte r completin g replacement o f fuel filter cartrid ge (1), open th e fuel valve under t he fue l tank a nd bleed th e air. For detail s, see "BLEEDING A IR FROM FUEL CIRCUIT (PA GE 4-40)". 8. Afte r completel y bleeding the a ir, start the engi ne and check t hat there is no l eakage of fuel fro m the filter seal surface. If any l eakag e of fuel i s found, check th at the filter ca rtridge is tightened proper ly. If th e fuel still l eaks, repe at Steps 1 and 2 t o remove the filter cartridg e, then check t he packing surface for da mage o r embedde d dirt. If an y problem i s foun d, replace the cartridge wit h a new part, t hen repeat Step s 3 - 8 to in stall th e new cartridge.