VEHICLE RECOVERY AND SPRING BRAKES Driver Controlled Main Differential CAUTION Follow these steps to lock a driver-controlled main differential. Failure to lift the driving wheels off the ground or remove the driveline and axle shafts before towing the ve- hicle could seriously damage your vehicle. All lubricating and clutch ap- plication oil pressure is provided by an engine-driven pump, which does not work when the engine is stopped. When vehicles are towed either by wrecker or piggyback, lubricant in the top front of the drive axle will drain to the rear. This will leave the top compo- nents dry, resulting in friction that will seriously damage these components.
2 An open air line on the recovered ve hicle will cause a leak in the air sys tem of the recovery vehicle if both ve hicles’ brake systems are connected. This could cause a loss of system air, which can cause the service brakes not to function, resulting in the sudden application of the spring brakes caus ing wheel lock-up, loss of control, or overtake by following vehicles. You could be in an accident involving death or personal injury. Ensure that any air line that has been removed from a driver-controlled main differential lock is firmly capped to prevent loss of air pressure from the recovery vehicle if it is supplying air pressure. WARNING!
Driver Controlled Main Differential Lock 1 Air Line (remove to install Caging Bolt) Caging Bolt (in storage location) 2 2. Cover open hubs when removing drive axle shafts. 1. Lift driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle. 2-16 Y53-1200-1B1 (04/13)