VEHICLE RECOVERY AND SPRING BRAKES CAUTION This action will lock the differential by pushing a piston into a position. CAUTION Water, dirt and other material can en ter an open hub or axle. This can con taminate the axle fluid and cause pos sible damage to components. Ensure that the hubs are covered with plas tic whenever a drive axle shaft is re moved. A recovered vehicle will have no op- erational brake system. Additionally, the rear axle spring brakes will prob- ably be applied. CAUTION 2 Failure to install the caging bolt when towing vehicles with driver-control main differential lock can result in damage by failing to lock internal com ponents in position.
If you desire to use the recovered vehicle’s brakes, ensure that the vehicles air system is connected to that of the recovery vehicle. Also ensure that any air line that has been removed from a driver-controlled main differential lock is firmly capped to prevent loss of air pressure from the recovery vehicle. 3. For vehicles with driver-controlled main differential lock, install the caging bolt before removing the axle shafts for towing. Ensure there are no open air lines on the recovered vehicle if the recovery vehicle and recovered vehicle brake systems are connected.
An open air line on the recovered vehicle will cause a leak in the air brake system of the recovery vehicle possibly causing death, personal injury, equipment or property damage. WARNING! a. Remove the air line and firmly cap. b. Remove the caging bolt from its storage hole. If you don’t desire to use the recovered vehicle’s brakes, ensure that you cage the spring brakes before attempting to move the vehicle. c. Screw the caging bolt into the air line hole. When fully engaged, a 0.25 - 0.5 in. (6.35-12.7 mm) space will remain between the air cylinder and the bolt head. 4. Install recovery hitches and rigging. (04/13) Y53-1200-1B1 2-17