Case IH AFX8010 — TRANSMISSION Hydrostatic

POWER TRAIN - TRANSMISSION Hydrostatic 19. Start and run the engine at low idle until a minimum pressure gauge reading of 20 bar (290 psi) is obtained. 20. Release the parking brake. 21. Slowly stroke the hydro to 1/2 stroke forward. Check to make sure that the transmission output shafts are turning properly. 22. Engage the rear wheel assist, if equipped. Make sure rear wheels are turning forward. Stroke the hydro and run the wheels forward for three minutes and then rearward for another three minutes. 23. Shift the combine into fourth gear and hold the brake pedals down. 24.

Move the hydrostatic lever slightly rearward until the pressure gauge plumbed into the forward (M1) port reads a minimum of 30 bar (4350 psi) . Do this for approximately 1 minute. 25. Move the hydrostatic lever slightly rearward until the pressure gauge plumbed into the forward (M2) ports reads a minimum of 30 bar (4350 psi) . Do this for approximately 1 minute. 26. Shut off the combine engine and check for oil leaks. Check the PTO gearbox oil level, and add as necessary. 27. Check for oil leaks. 28. Restart the combine engine. With the gearshift in neutral and engine speed at low RPM, place the hydrostatic lever at half stroke for one minute in forward and reverse. 29.

With the gearshift still in the neutral position, increase the throttle to full engine RPM. Move the hydro handle to maximum stroke for two minutes in both forward and reverse. 30. Move the gearshift to 4th gear and set engine speed to high idle. Apply maximum stroke on the control lever in forward position for a maximum of 10 seconds. Pressure should be 420 - 460 bar (6092 - 6672 psi) ; repeat the procedure for reverse. 31. Press the switch (1) to engage the separator (perform only if shields are closed). Verify cleaning fan and spreader direction. Disengage the separator and operate the feeder reverser and rotor reverser for 10 seconds. 50030140A5 12 9681 1 27/05/2004 C.20.F / 17