Case IH AFX8010 — TRANSMISSION Hydrostatic

POWER TRAIN - TRANSMISSION Hydrostatic Command - Pressure test (C.20.F.05 - F.40.A.30) AFX8010 The following testing procedure requires the use of the special tools listed below: CAS-10257 - Pressure Gauge 0 - 40 bar (0 - 600 psi) (or) CAS-10095 - Quad Gauge (or) CAS-10757 - Hydrostatic Test Set (or) CAS-1803-1 - Quick Release (Female) FITTINGS - PARKER HANNIFIN PART NUMBER PD361 - Coupler, Male (9/16"- 18 UNF)[part#86596853] Prior operation: Relief valve - Pressure test (C.20.F.16 - F.40.A.30) - Various Pressure and vacuum gauge readings are necessary for troubleshooting problems with the main hydrostatic drive system.

To check the high pressure settings of the multi function valves it will be necessary to connect high pressure gauges to the system. Measuring the charge pump inlet vacuum assists in locating restrictions in the return lines, oil cooler and filter screen. The pump and motor charge pressure readings are obtained, the system must be at normal operating temperature and at full rated engine speed. WARNING M953 - Gauges, fittings and hoses MUST have operating pressure ratings of a least 25 percent higher than the highest pressure of the circuit being tested. CAUTION 46-77A - Before you do service under the machine, put the machine on a level surface, engage the parking brake and stop the engine.

Put blocks at the front and rear of the tires. Failure to follow these instructions can cause injury. CAUTION M142A - Never operate the engine in a closed building. Proper ventilation is required under all circumstances. IMPORTANT: The interior of all test equipment must be exceptionally clean before being used to test the hydrostatic drive system. Make sure the test equipment is purged of all oil and foreign material to avoid contamination of the hydrostatic drive system. 1. Testing the servo pressure requires gauges to be installed into the X1 (1) and X2 (2) ports of the control unit, located on the front side of the hydrostatic pump. Remove the plugs and install the male quick coupler.

10033623A5 1 9681 1 27/05/2004 C.20.F / 19