DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM WIRING HARNESS REPAIRS Temporary Wiring Harness Repair The following method to repair wiring is a temporary expedient only. Wiring should be replaced as soon as possible. Do not attempt to repair the wire on any sys- tem sensors as these are sealed and should only be replaced with a new component. NOTE: When conducting a cable repair it is import- ant that only RESIN CORED SOLDER is used. Use of other types of solder may result in further cable damage. To carry out a temporary repair, proceed as follows:- 1. Locate damaged portion of cable then cut away outer protective cover on both sides of the dam- aged area. 4 2.
Peel back the cable from both ends of the dam- aged area and carefully cut away the inner cable cover at the damaged area and strip about 13 mm (1/2 ) of insulation from the wires. Do not cut away any wire strands. 3. Using a suitable solvent, clean about 2 inches (50 mm) from each cover end. Clean the grey cable cover and the individual leads. 4. Twist two bare leads together for each damaged lead, being careful to match wire colours, then solder the leads using resin cored solder. Tape each repaired lead with vinyl insulation tape. 5 A.30 / 5F