DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM THE DIGITAL MULTI-METER NOTE: This section is only intended as a general guide to using a digital multimeter. Always refer to the manufacturer’s operators manual for correct operation. A multimeter is an electronic measuring device. The different types of measurement that can be made depend upon the make and model of the multimeter. Most types of multimeter have the capacity to measure: Current (A) ac or dc Resistance ( Ω ) Voltage (V) ac or dc Continuity (Buzz test) More expensive multimeters have other functions, such as the capacity to measure frequency (Hz) and test diodes. 10 General Operation:
Before proceeding with a test, decide on what is going to be measured (Voltage, Current etc.). Rotate the dial until the pointer is within the relevant zone. Within each zone there are different scales. The scale that is selected will represent the maximum value that the multimeter will read. Always select a scale which is greater than the value that you intend to measure. If you are unsure of the value to be measured, always select the highest scale and then reduce the scale once you have an idea of the measured value. 11 Why are there different scales ? The closer that the scale is to the measured value, the more accurate the reading will be e.g.
If measuring the voltage of a battery with the scale set at 200V, the display may read 12V. However, if the scale was set to 20V the display may read a more accurate reading of 12.27V. 12 A.30 / 5I