CROP PROCESSING - FEEDING Feeder housing FEEDING Feeder housing - Install (K.25.E - F.10.A.15) AFX8010 1. Before installing the feeder house onto the combine, generously lubricate the pivot points on the combine frame. The feeder weighs approximately 1195 - 1285 kg ( 2634 - 2833 lb ) use care when installing the feeder to the combine. DANGER M184D - ALWAYS shut OFF engine, remove the key and engage feeder safety lock in position on lift cylinder before working under header or feeder. Failure to engage feeder safety lock may cause injury or death. 2. Attach a chain from the forklift to the rear of the feeder housing.
With the feeder attached to the forklift, install the feeder back to the front of the combine. Have an assistant make sure the feeder is properly aligned. DANGER 84-102 - Improper service or repair can cause injury or death. If you do not understand the service procedures for this machine, see your dealer or the Service manual. 10030323 1 3. Place suitable jackstands under the front of the feeder housing. 40030040 2 9712 1 27/05/2004 K.25.E / 10