CROP PROCESSING - STORING AND HANDLING Grain storing 6. Disconnect the grain bin 3/4 full switch S-28 connector X107 . A. If the voltage drops to 0 - 4.9 volts , continue with step 7 . B. If the voltage remains high (> 4.9 volts ) out of range, continue with step 8 . 7. Disconnect the grain bin 3/4 full switch S-28 connector X107 . Use a multimeter to check for voltage on connector X107 pins A and B. A. If there is high (> 5 volts ) voltage on connector X107 pin A, the regulated voltage supply is incorrect. The fault code E0165-03 - CCM2 J2 5V Reference should be listed in the "ERROR" screen on the Universal Display Plus.
Correct that fault code, and then check to determine if this error has been resolved. B. If there is voltage on connector X107 pin B, there is a short to high voltage in the grain tank (GT) harness between connector X109 pin B and connector X107 pin B wire 445 yellow. Locate the short and repair. 8. Disconnect the grain bin 3/4 full switch S-28 connector X107 . Use a multimeter to check for voltage on connector X107 pin C. There should not be any voltage. A. If no voltage is found, continue with step 10 . B. If high (> 4.9 volts ) voltage is found, continue with step 9 . 9. Disconnect the main frame (MF) harness from the grain tank (GT) harness at connector X009 .
Use a multimeter to check for voltage on the main frame (MF) harness end of connector X009 pin E. There should not be any voltage. A. If no voltage is found, there is a short in the grain tank (GT) harness between connector X107 pin C and connector X009 pin E wire 400 yellow. Locate the short and repair. B. If high (> 4.9 volts ) voltage is found, there is a short in the main frame (MF) harness between connector X009 pin E and connector X016 pin J2-22 wire 400 yellow. Locate the short and repair. 10. Operate the machine while monitoring the Universal Display Plus "DIAG" screen, "TANK FULL SEN" voltage. A.
If no high (> 4.9 volts ) out of range readings are indicated, erase the fault code and continue operation. Sensing system Level sensor - Overview (K.60.B.95.80 - C.10.A.10) 10030023A5 1 Grain Bin Level Sensors 1. Grain bin full switch S-29 2. Grain bin 3/4 full switch S-28 3. Connector X109 4. Connector X107 Two grain bin switches are used to monitor the level of material in the grain bin. The grain bin 3/4 full switch S-28 (2) is located in the center of the front grain tank wall, just above the cab window, while the grain bin full switch S-29 (1) 9716 1 27/05/2004 K.60.B / 63