DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Wiring harness - Electrical schematic frame 35 (A.30.A.88 - C.20.E.35) The first path sends current through connector X024 to reach a wire splice. The wire splice sends current to two different paths. The first path sends current through connector X285 to reach pin 58R of the trailer outlet J-09. The second path sends current through connector X071 to reach a wire splice. The wire splice splits the current into two different paths. The first path (North American Models) sends current to the RH Brake / Tail Lamp (NA) (E-12).
The ground path to the RH Brake / Tail Lamp (NA) exits pin C and travels through a wire splice and connector X071 to reach the rear frame ground location #1. This causes the RH Brake / Tail Lamp (NA) to illuminate. The second path (European Models) sends current to pin 2 of the RH Rear Flashing Lamp (EU) (E-06). The ground path to the RH Rear Flashing Lamp (EU) exits pin 4 and travels through a wire splice and connector X071 to reach the rear frame ground location #1. This causes the RH Rear Flashing Lamp (EU) to illuminate.
Wiring harness - Electrical schematic frame 37 (A.30.A.88 - C.20.E.37) The second path (European Models Only) sends current to LH Flip Up Road Light (E-47) and RH Flip Up Road Light (E-48). Wiring harness - Electrical schematic frame 34 (A.30.A.88 - C.20.E.34) The third path sends current through connector X165 to reach a wire splice. The wire splice sends current to the RH Front Hazard Lamp (E-04), RH Position Lamp (E-49) (European Models Only), and the RH Front Austria Lamp (E-53). The ground paths to the lights listed above travel through a wire splice and connector X165 to reach the front frame ground location #2. This causes the lights to illuminate.
License Plate Lights (European Models Only) Wiring harness - Electrical schematic frame 35 (A.30.A.88 - C.20.E.35) If equipped with license plate lights, a jumper harness will be plugged into connector X302 . When the marker lights are on, current flows through pin 2 of connector X302 to reach a wire splice. The wire splice splits the current into three paths. The first path sends current to pin 1 of the LH License Plate Lamp (EU) (E-58). The ground path to the LH License Plate Lamp (EU) exits pin 2 and travels through two wire splices and connector X071 to reach the rear frame ground location #1. This causes the LH License Plate Lamp (EU) to illuminate.
The second path sends current to pin 2 of the RH Rear Flashing Lamp (EU) (E-06). The ground path to the RH Rear Flashing Lamp (EU) exits pin 4 and travels through a wire splice and connectors X302 and X071 to reach the rear frame ground location #1. This causes the RH Rear Flashing Lamp (EU) to illuminate. The third path sends current to the RH License Plate Lamp (EU) (E-57). The ground path to the RH License Plate Lamp (EU) exits pin 2 and travels through two wire splices and connector X071 to reach the rear frame ground location #1. This causes the RH License Plate Lamp (EU) to illuminate. 9668 1 27/05/2004 A.40.A / 12