DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Beacon - Overview (A.40.A.15 - C.10.A.10) AFX8010 Wiring harness - Electrical schematic frame 39 (A.30.A.88 - C.20.E.39) The AFX Combine is equipped with three beacon lights. There are two beacon lights mounted to the cab roof and one mounted at the rear railing of the combine (engine platform). Three things cause the beacon lights to activate: Beacon Switch pressed to the "On" position. Initial Startup - Beacon Lights illuminate when the ignition key is moved from the "Off" position. Grain Bin Becoming Full - The combine is equipped with a lower (3/4) and upper (bin full) grain tank level sensor.
These sensors monitor the level of material in the grain bin. When the thresher is engaged and the material in the grain bin reaches the lower sensor, the rotating beacons will flash (If the work lights are activated, the rotating beacons will only flash for approximately 10 seconds. The rotating beacons flash again for another 10 seconds when the upper sensor detects material). The flashing beacons inform a grain truck operator to prepare for unloading the grain bin. NOTE: The beacon light circuit shows the beacon switch in the "On" position. Description Current flows through the electrical system buss bar and passes through fuse F-53 to reach pin 3 of the beacon light relay (K-29).
Current flow to the coil within the beacon light relay (Pin 1) is controlled by CCM-2. If one of the three conditions listed above occurs, current travels from CCM-2 connector X015 pin J1-24 to the beacon light relay pin 1. The ground path exits pin 2 and travels to the cab floor ground location #3. This energizes the relay. The beacon light relay latches and current crosses from pin 3 to reach pin 5. From pin 5, current flows to two different paths. The first path sends current through connectors X004 , X024 , and X071 to reach pin 1 of connector X247 . Current enters pin 1 and reaches the rear beacon light (E-33).
The ground path exits pin 2 and travels through a wire splice, and connector X071 to reach the rear frame ground location #1 (refer to Wiring harness - Electrical schematic frame 08 (A.30.A.88 - C.20.E.08) for complete ground path). This activates the rear beacon. The second path sends current through connectors X002 , and X036 to reach a wire splice. The wire splice splits the current into two paths: The first path sends current to pin 1 of connector X113 . Current enters pin 1 to reach the LH Front Beacon Light (E-31). The ground path exits pin 2 and travels through a wire splice and connector X036 to reach the cab roof ground location #4. This causes the LH Front Beacon light to activate.
The second path sends current to pin 1 of connector X119 . Current enters pin 1 to reach the RH Front Beacon Light (#32). The ground path exits pin 2 and travels through a wire splice and connector X036 to reach the cab roof ground location #4. This causes the RH Front Beacon Light to activate. 9668 1 27/05/2004 A.40.A / 19