Case IH AFX8010 — LIGHTING SYSTEM

DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Cleaning shoe service light - Overview (A.40.A.20 - C.10.A.10) AFX8010 SIEVE LIGHT Wiring harness - Electrical schematic frame 42 (A.30.A.88 - C.20.E.42) The sieve lights are used to illuminate the top of the cleaning shoe in the combine, to facilitate cleaning or adjustments. When the Key Switch (S-02) is in the "Start" or "Run" positions, current flows through the electrical system buss bar K-03 to reach the Service Lights Fuse (F-14). Current passes through fuse (F-14) and connectors X004 and X024 to reach pin A of the Sieve Light Switch (S-54). When the switch is moved to the "ON" position, current crosses to pin B and travels to a wire splice.

The wire splice splits the current into two paths: The first path sends current to pin A of Sieve Light Front (E-37). The ground path to the Sieve Light Front (E-37) exits pin B and travels to the Rear Frame Ground location #1. This causes the light to illuminate. The second path sends current to pin A of Sieve Light Rear (E-59). The ground path to the Sieve Light Rear (E-59) exits pin B and travels to the Rear Frame Ground location #1. This causes the light to illuminate. NOTE: The sieve lamps are used to provide light inside the threshing area while making adjustments and repairs. The lamp housing incorporates a thermostatic circuit breaker that will prevent the lamps from over heating.

If the housing should get too hot due to debris buildup or extended usage, the breaker will open and reset itself when the unit has cooled sufficiently. 9668 1 27/05/2004 A.40.A / 27