Case IH AFX8010 — LIGHTING SYSTEM

DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Brake light Relay - Testing (A.40.A.14.82 - G.40.A.20) AFX8010 Brake light Wiring harness - Testing (A.40.A.14.88 - G.40.A.20) AFX8010 9668 1 27/05/2004 A.40.A / 45 N° Test Point Expected Result Other Result (Possible Cause) 1 Depress brake pedal. Measure for 12 volts at Brake Lights Relay K-33 (pin 5). 12 volts If good reading, the relay is OK. Brake Lights Relay K-33. Adjacent circuits. Go to test 2 2 Depress brake pedal. Measure for 12 volts at Brake Lights Relay K-33 (pin 1). 12 volts If good reading, Go to test 3 Open or short to ground in circuit 183 (WH) between Brake Lights Relay K-33 (pin 1) and CCM-2 connector X015 (pin J1-18).

See Service manual for testing of CCM. 3 Measure for 12 volts at Brake Lights Relay K-33 (pin 3). 12 volts If good reading, Go to test 4 Open circuit 56 (RD) between Brake Lights Relay K-33 (pin 3) and Fuse #52. Short to ground on circuit 78 (PU) between Brake Lights Relay K-33 (pin 5) and Brake Lamps. A short will cause Fuse #52 to blow. 4 Disconnect the Brake Lights Relay K-33. Measure resistance on circuit 159 (BK) between Brake Lights Relay K-33 (pin 2) and ground. Less than 1 ohms. If good reading, Open circuit 159 (BK) between Brake Lights Relay K-33 (pin 2) and ground. N° Test Point Expected Result Other Result (Possible Cause) 1 Place Key Switch S-02 in ON position.

Depress brake pedal. Measure for 12 volts at Brake Light Relay K-33 (pin 5). 12 volts If good reading, go to next test point. Perform Brake Light Relay Test. 2 Depress brake pedal. Measure for 12 volts at LH Brake/Tail Lamp E-11 connector X299 (pin 1). 12 volts If good reading, go to next test point. Open circuit 629 (PU) between Brake Light Relay K-33 (pin 5) and LH Brake/Tail Lamp E-11 connector X299 (pin 1). Short to ground on circuit 629 (PU) between Brake Light Relay K-33 (pin 5) and LH Brake/Tail Lamp E-11 connector X299 (pin 1). Any short to ground will blow the Fuse #52. 3 Disconnect the LH Brake/Tail Lamp E-11.

Measure the resistance on circuit 634 (BK) between LH Brake/Tail Lamp E-11 connector X299 (pin 2) and ground. Less than 1 ohms. If good reading, replace the brake bulb of the LH Brake/Tail Lamp E-12. Open in circuit 634 (BK) between LH Brake/Tail Lamp E-11 connector X299 (pin 2) and ground. 4 Place Key Switch S-02 in ON position. Depress brake pedal. Measure for 12 volts at Brake Light Relay K-33 (pin 5). 12 volts If good reading, go to next test point. Perform Brake Light Relay Test.