DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Engine component service light Switch - Testing (A.40.A.21.83 - G.40.A.20) AFX8010 IMPORTANT: Do not use a self-powered test light for any of these tests. Use of a self powered test light can cause damage to components in this system. WARNING M980 - Before performing any of the electrical tests, be sure all operating controls are in neutral or park lock position. This will eliminate accidental movement of the machine or start-up of power driven equipment.
Engine component service light Wiring harness - Testing (A.40.A.21.88 - G.40.A.20) AFX8010 9668 1 27/05/2004 A.40.A / 81 N° Test Point Expected Result Other Result (Possible Cause) 2 Measure for 12 volts at Sieve Light E-37 connector X234 (pin A). 12 volts If good reading, Go to test 3 Open circuit 610 (PU) between Sieve Light Switch S-54 connector X237 (pin 3) and Sieve Light E-37 connector X234 (pin A). 3 Disconnect the Sieve Light E-37. Measure the resistance on circuit 611 (BK) between Sieve Light E-37 connector X234 (pin B) and ground. Less than 1 ohms If good reading, replace the Sieve Light bulb. Open circuit 611 (BK) between Sieve Light E-37 connector X234 (pin B) and ground.
N° Test Point Expected Result Other Result (Possible Cause) 1 Place Engine Light Switch S-64 in ON position. Measure for 12 volts at Engine Light Switch S-64 connector X340 (pin 2). 12 volts. If good reading, Go to test 2 Open or short circuit 1215 (RD) and Fuse #34. 2 Place Engine Light Switch S-64 in ON position. Measure for 12 volts at Engine Light Switch S-64 connector X340 (pin 1). 12 volts. Replace Engine Light Switch (S-64). N° Test Point Expected Result Other Result (Possible Cause) 1 Perform test on Engine Light Switch (S-64) to determine the switch is functioning properly. Move the Engine Light Switch to the ON position.
Disconnect the Engine Light (E-46) from the wiring harness and measure voltage at pin A of connector X349. 12 volts Problem with circuit 1248 (BK). Replace or repair as necessary. 2 Disconnect the Engine Light (E-46) from the wiring harness and measure continuity at pin B of connector X349. Less than 1 ohms If good reading, replace the Engine Service Light bulb. Open circuit 1248 (BK). Repair or Replace wiring harness.