Case IH AFX8010 — ELECTRONIC SYSTEM

DISTRIBUTION SYSTEMS - ELECTRONIC SYSTEM 2. Refer to the power and ground chart below for the specific power and ground sources for each module. Use a multimeter to test for continuity to ground on the ground path, and for 12V power on the supply wires. If the module power and ground supplies are good, but the module is still offline, continue with step 3. NOTE: KAM* = Keep Alive Memory; constant, key-off power.

A.50.A / 108 Module Power Ground Comments YMIU Connector X438 pin 10 wire 1232 orange Connector X438 pin 12 wire 1287 black/white • Power from fuse F47 • Ground to battery clean ground GPS Connector X321 pin 1 wire 1238 orange Connector X321 pin 3 wire 1239 black/white • Power from fuse F45 • Ground to battery clean ground CCM1 • KAM* power @ connector X018 pin J1-1 wire 052 red • Main power @ connector X018 pin J1-4 wire 099 red • Connector X018 pin J1-8 wire 215 black • Connector X019 pin J2-12 & 18 wires 686 & 687 black • KAM power from fuse F39 • Main power from fuse F38 through key switch • Refer to schematic frame 29 CCM2 • KAM* power @ connector X015 pin J1-1 wire 050 red • Main power @ connector X015 pin J1-4 wire 100 red • Connector X015 pin J1-8 wire 216 black • Connector X016 pin J2-12 & 18 wires 688 & 689 black • KAM power from fuse F39 • Main power from fuse F38 through key switch • Refer to schematic frame 29 CCM3 • KAM* power @ connector X012 pin J1-1 wire 049 red • Main power @ connector X012 pin J1-4 wire 101 red • Connector X012 pin J1-8 wire 217 black • Connector X013 pin J2-12 & 18 wires 690 & 691 black • KAM power from fuse F39 • Main power from fuse F38 through key switch • Refer to schematic frame 29 RHM • KAM* power @ connector X026 pin 13 wire 051 red • Main power @ connector X026 pins 4 & 5 wires 098 & 089 orange Connector X026 pins 15 & 20 wires 389 & 352 black • Main power from fuse F42 through Cab power relay K26 to fuse F48 • Ground path though connec- tor X001 pin 12 • Refer to schematic frames 25, 28 & 29 SSM Connector X064 pin C wire 097 orange Connector X064 pin F wire 145 black • Power from fuse F38 through key switch • May also test at white plastic circuit board connector X320 prior to replacing module GOV (ECU) Connector X193 pin 3 & 4 wires 810 & 811 white.

Connector X193 pins 1 & 2 wires 815 & 816 black • Main power from fuse F01 through ECU Power relay K14 • Refer to schematic frame 2