DISTRIBUTION SYSTEMS - ELECTRONIC SYSTEM 4. Use a multimeter to check the resistance between the console harness end of connector X001 pins 6 & 7. A. If there is 0 ohms resistance, there is a short in the right console (RC) harness between connector X001 and the RHM connector X026 wires 127 & 129 yellow and 128 & 130 green. Locate the short and repair. B. If there is infinite resistance, continue with step 5. 5. Disconnect connector X193 from the ECU (engine control unit) on units with electronically controlled engines, or unplug the CAN node connector X291 on units with mechanically controlled engines. Use a multimeter to check for continuity between connector X001 pins 8 and 9. A.
If there is no continuity, there is a fault in the ECU. Replace the ECU. B. If there is continuity, continue with step 6. 6. Disconnect the engine harness at connector X010. Use a multimeter to check for continuity between connector X001 pins 8 and 9. A. If there is no continuity, there is a short in the engine (EN) harness between connector X193 and connector X010 wires 819 yellow and 820 green. Locate the short and repair. B. If there is continuity, continue with step 7. 7. Disconnect the main frame harness from the expansion harness at connector X034. Use a multimeter to check for continuity between connector X001 pins 8 and 9. A.
If there is no continuity, there is a fault in the main frame (MF) harness between connector X010 and connector X034 wires 819 yellow and 820 green. Locate the short and repair. B. If there is continuity, continue with step 8. 8. Disconnect the expansion harness from the main frame harness at connector X034A. Use a multimeter to check for continuity between connector X001 pins 8 and 9. A. If there is no continuity, there is a short in the expansion (EX) harness between connector X034 and connector X034A wires 819, 1230 & 1251 yellow and 820, 1231 & 1252 green. Locate the short and repair. B. If there is continuity, continue with step 9. 9.
Disconnect the main frame harness from the CCM2 module at connector X016. Use a multimeter to check for continuity between connector X001 pins 8 & 9. A. If there is no continuity, there is a short in the main frame (MF) harness between connector X009 and connector X016 wires 744 yellow and 746 green. Locate the short and repair. B. If there is continuity, continue with step 10. 10. Disconnect the cab main harness from the CCM3 module at connector X012. Use a multimeter to check for continuity between connector X001 pins 8 & 9. A. If there is no continuity, there is a fault in the CCM3 module. Replace the module. B. If there is continuity, continue with step 11. 11.
Disconnect the cab main harness from the CCM2 module at connector X015. Install jumper wires on the cab main half of connector X015 between pins J1-13 & J1-19 and between pins J1-14 & J1-20. Use a multimeter to check for continuity between connector X001 pins 8 & 9. A. If there is no continuity, there is a fault in the CCM2 module. Replace the module. B. If there is continuity, continue with step 12. A.50.A / 111