DISTRIBUTION SYSTEMS - ELECTRONIC SYSTEM 3. Disconnect connector X064 in the right cab post. Use a multimeter to check for continuity between the adapter display harness end of connector X064 pin A and resistor connector pin B. A. If there is infinite resistance, there is an open circuit in the adapter display (AD) harness between connector X064 and the termination resistor connector in the following wires: Wire 143 yellow, connector X064 pin A to AD harness splice Wire 1173 yellow, AD harness splice to AD harness splice Wire 1207 yellow, AD harness splice to resistor connector pin B Locate the open and repair. B. If there is 0 ohms resistance, continue with step 4. 4.
Use a multimeter to check for continuity between the adapter display harness end of connector X064 pin E and resistor connector pin A. A. If there is infinite resistance, there is an open circuit in the adapter display (AD) harness between connector X064 and the termination resistor connector in the following wires: Wire 144 green, connector X064 pin E to AD harness splice Wire 1174 green, AD harness splice to AD harness splice Wire 1208 green, AD harness splice to resistor connector pin A Locate the open and repair. B. If there is 0 ohms resistance, continue with step 5. 5.
Use a multimeter to check for continuity between the cab main harness end of connector X064 pin A and connector X001 pin 6. A. If there is infinite resistance, there is an open circuit in the cab main (CM) harness between connector X064 and connector X001 wires 143 and 127 yellow. Locate the open and repair. B. If there is 0 ohms resistance, continue with step 6. 6. Use a multimeter to check for continuity between the cab main harness end of connector X064 pin E and connector X001 pin 7. A. If there is infinite resistance, there is an open circuit in the cab main (CM) harness between connector X064 and connector X001 wires 144 and 128 green. Locate the open and repair. B.
If there is 0 ohms resistance, continue with step 7. 7. Use a multimeter to check the resistance between the console harness end of connector X001 pins 6 & 8. A. If there is infinite resistance, there is an open circuit in the right console (RC) harness between connector X001 pin 6 & 8 wires 127 & 129 yellow. Locate the open and repair. B. If there is infinite resistance, continue with step 8. 8. Use a multimeter to check the resistance between the console harness end of connector X001 pins 7 & 9. A. If there is infinite resistance, there is an open circuit in the right console (RC) harness between connector X001 pin 7 & 9 wires 128 & 130 yellow. Locate the open and repair. B.
If there is infinite resistance, continue with step 9. 9. Disconnect the cab main harness from the CCM1 module at connector X018. Install a jumper wire on the cab main end of connector X018 between pins 19 & 20. Use a multimeter to check for continuity between connector X001 pins 8 & 9. A. If there is no continuity, there is an open circuit in the cab main (CM) harness between connector X001 and connector X018 wires 129 yellow or 130 green. Locate the open circuit and repair. B. If there is continuity, continue with step 10. 10. Remove the jumper wire from the cab main end of connector X018. Use a multimeter to check for continuity between connector X018 pins J1-13 and J1-14. A.
If there is continuity (approx. 120 ohms), there is a fault in the CCM1 module. Replace the module. B. If there is no continuity, continue with step 11. A.50.A / 113