POWER PRODUCTION - ENGINE 21. Using an appropriate wrench and a hex wrench, unscrew screws (1) and (2) and remove the sub-crankcase (3) IMPORTANT: Make note of the assembly position of the top and bottom main bearing shells since, if they are to be reused, they must be fitted in the same position as found in disassembly. mid0313a 17 22. Using tool 380000362 , (1) , remove the crankshaft (2) . mid0314a 18 23. Remove the main bearing shells (1) . Unscrew the screws and remove the oil nozzles (2) . Remove the cylinder liners as described in Cylinder block - Replace (B.10.A.70 - F.10.A.30) . For crankcase service assembly information, see ENGINE - Assemble (B.10.A - F.10.A.20) .
mid0315a 19 9671 1 27/05/2004 B.10.A / 49