POWER PRODUCTION - ENGINE 3. Place the gasket on the oil pan (2) , position the spacer (3) and fit the sump on the crankcase, screwing down the screws (1) , to the required torque. Refer to Oil pan - Torque (B.60.A.23 - D.20.A.10) for torque information. 50034760A5 3 4. Mount the following, tightening the fixing screws to the required torque: starter motor (1) ; control unit (2) (Refer to Sensing system - Torque (B.50.A.95 - D.20.A.10) ), and its mount; oil dipstick (3) , in the crankcase. IMPORTANT: Check the state of the elastic elements of the control unit mount and replace them if they are deteriorated. mid0367a 4 5.
Fit the intake manifold (1) and tighten the fixing screws (2) , to the required torque. 19082003601429 5 6. Fit the oil filter mount and tighten the fixing screws to the required torque. Connect the oil pipes (3) , to the mounts tightening the fittings to the required torque. 50030330A5 6 9671 1 27/05/2004 B.10.A / 51