POWER PRODUCTION - ENGINE 8. With the centering ring (2) 380000169 , position the front cover (1) , on the crankcase. Screw down the screws and tighten them to the required torque, as noted in Crankshaft - Torque (B.10.A.43 - D.20.A.10) . 260820031233549 8 9. Key the ring seal (1) , onto the crankshaft, on which you should apply the tool (2) , 380000126 . Screw down the nut (3) , to mount the ring seal (1) , completely in the cover (2) . 290820031478855 9 10. The diagram on the right shows the tightening sequence of the screws fixing the sub-crankcase under the crankcase. 270820031315613 10 11.
The clearance between the crankshaft bearings and the relevant pins is measured by comparing the width taken on by the plasti-gauge (2) , at the point of greatest crushing with the graduated scale on the case (1) , containing the plasti-gauge wire. The numbers given on the scale give the clearance of the coupling in millimeters. If you find the clearance is not as required, replace the half bearings and repeat the check. 270820031316515 11 9671 1 27/05/2004 B.10.A / 73