Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE 12. Crankshaft end play is checked by placing a dial gauge (1) , with a magnetic base on the crankshaft (2) , as shown. If you find the clearance is higher than as required, replace the rear main thrust bearing shells and repeat the clearance check. 270820031316656 12 13. Before replacing the oil pump and timing system gear, check that the teeth of the gear are not damaged or worn. If damage or excessive wear is found, remove the gear with the appropriate extractor and replace it. When fitting the gear (1) , on the crankshaft (2) , heat it for approximately 15 minutes in an oven at a temperature of 180 °C ( 356 °F ). After driving it home, leave it to cool.

IMPORTANT: After heating the gear (1) , fit it on the shaft by applying a load of 6000 Nm ( 1350 lb ft ) to the gear, positioning the load at the distance shown in the figure on the right. After cooling, the gear must have no axial movement under a load of 29100 Nm ( 6547.5 lb ft ). 290820031486131 13 14. To replace the crankshaft front cover seal, drain off the coolant from the engine cooling system. Disconnect the pipes from the thermostat housing. Using a suitable tool (6) , turn in the direction of the arrow on the tightener (5) and remove the belt (4) . Using a suitable tool (3) , turn in the direction of the arrow on the tightener (2) and remove the belt (1) .

Take out the fixing screws and remove the damper flywheel (7) and the pulley beneath. mid0506a 14 9671 1 27/05/2004 B.10.A / 74