POWER PRODUCTION - ENGINE 9. The ring seal (2) , of the first slot is trapezoidal in shape. The clearance "X" between the ring seal and its seat is measured by placing the piston (1) , with the ring in the cylinder liner (3) , so that the ring seal is half out of the cylinder liner. mid0428a 8 10. Using a feeler gauge (2) , check the opening between the ends of the ring seals (1) , inserted in the cylinder liner (3) . On finding a higher or lower distance between the ends than is required, replace the piston rings. IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. mid0429a 9 11.
Clean the parts thoroughly before performing any work. 12. Main data for the connecting rod, bushing, pin and half bearings are shown on the right (dimensions are in mm). Dimensions indicated with an (*) should be obtained after driving home the bushing. The data for the classes of selection for the big end bearing seat and weights are punched on the big end of the connecting rod. mid0431a 10 9671 1 27/05/2004 B.10.A / 84