POWER PRODUCTION - ENGINE 13. The bushing (2) , is disassembled and assembled with the appropriate drift (1) . IMPORTANT: After driving home the bushing in the small end of the connecting rod, remove the portion that comes out of the side, then rebore the bushing in order to obtain the required diameter. mid0433a 11 14. The alignment of the connecting rod, twisting and bending is checked with the appropriate tool. Check the alignment of the connecting rods (1) , as follows: Fit the connecting rod (1) , on the spindle of the tool (5) and lock it with the screw (4) . Place the spindle (3) , on the V-prisms resting the connecting rod (1 ) , on the stop bar (2) . mid0435a 12 15.
Check the twist of the connecting rod (5) , by comparing two points (A and B) of the pin (3) , on the horizontal plane of the connecting rod. Position the mount (1) , of the dial gauge (2) , so that the latter is pre-loaded by approximately 0.5 mm ( 0.020 in ) on the pin (3) , at point A and zero the dial gauge (2) . Move the spindle (4) , with the connecting rod (5) and on the opposite side (B) of the pin (3) , compare any deviation: the difference between A and B must be no greater than 0.08 mm ( 0.003 in ). mid0436a 13 9671 1 27/05/2004 B.10.A / 85