Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE 16. Check the bend of the connecting rod (5) , by comparing two points C and D of the pin (3) , on the vertical plane of the connecting rod. Position the vertical mount (1) , of the dial gauge (2) , so that the latter rests on the pin (3) , at point C. Swing the connecting rod forwards and backwards, searching for the highest position of the pin and zero the dial gauge (2) , in this condition. Move the spindle with the connecting rod (5) and on the opposite side D of the pin (3) , repeat the check for the highest point. The difference between points C and D must be no greater than 0.08 mm ( 0.003 in ). mid0437a 14 17.

A piston-connecting rod assembly consists of the following parts: (1) , connecting rod body; (2) , half bearings; (3) , connecting rod cap; (4) , cap fixing screws; (5) , split ring; (6) , oil scraper ring with slots with spiral spring; (7) , ring seal; (8) , trapezoidal ring seal; (9) , piston pin and (10) piston. mid0438a 15 9671 1 27/05/2004 B.10.A / 86