POWER PRODUCTION - FUEL AND INJECTION SYSTEM mid0494a 2 The solenoid, which is energized at each active phase in the cycle, governs a slide valve with a signal from the control unit that shuts off the delivery pipe of the pumping element. When the solenoid is not energized, the valve is open. Fuel is pumped but it flows back into the return pipe with the standard transfer pressure of approximately 5 bar ( 72.5 psi ). When the solenoid is energized, the valve closes. As the fuel cannot flow back into the return pipe, it is pumped into the nozzle at high pressure, causing the needle to lift.
The amount of fuel injected depends on the closing time of the slide valve and hence on how long the solenoid is energized. The solenoid valve is joined to the injector body and cannot be removed. On the top there are two screws securing the cables transmitting the signal from the control unit. To ensure signal transmission, tighten the screws with a torque wrench 380000158 to a torque of 1.36 - 1.92 Nm (0.136 - 0.192 kgm [ 12 - 17 lb ft ]). FIG_235 3 9672 1 27/05/2004 B.20.A / 6