Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

94 CHAPTER FIVE Fuel transfer pump lobe Intake valve lo be Exhau st valve lobe / 6. Remove the bearing retaining screw (Fig ure 83), then withdraw the camshaft. 7. Remove the valve lifters and mark them so they may be reinstalled in their original locations. 8. Check the rear bearing journal and lobes for signs of wear or sconng . 11. Replace the ball bearing if it is damaged or feels rough during rotation. 12. Installation is the reverse of removal . Note the fol- lowing: a. If installing a new camshaft, coat the camshaft lobes with camshaft break-in lubricant. Ifrcinstalling tbc original camshaft, apply heavy oil to the camshaft lobes. b.

Lubricate the camshaft bearing journal with heavy engine oil before reinstallation. c. Lightly tap the end of the camshaft to seat the ball bearing in the engine. Rotate the camshaft 10be sure it rotates freely. d. Align the timing marks (Fig ure 78) on the camshaft and crankshaft gears when installing the camshaft gear. c. Install the fuel injection cam so the side marked with a zero is out (Figure 85). f. Check gear backlash by installing a dial indicator as shown in Figure 79 or by rotating the gear teeth with soft solder between the gear teeth. Compare NOTE If precision measuring equipment is not available, have a dealership or machine shop perform Step 9. 9.

Measure the rear camshaft journal diameter and lobes (Figure 84) and compare the measurement 10the specifi- cation in Table I. Replace the camshaft if the journal or lobes do not meet specifications. 10. Measure the stem diameter of the valve lifters and compare the measurement to the specificat ion in Table I. Measure the lifter bores in the cylinder block. Calculate the lifter clearance and compare it with the specification in T ab le L Replace the valve lifters if they do not meet specifications. Replace the valve lifter if the lifter face is scored, galled, excessively worn or otherwise damaged.