SINGLE-CYLINDER ENGINES 95 Straight edge ~ -=o Feeler --.....~ ~ gauge \..) ___ 5 face s. Che ck all core plugs for leaks and replace any that are suspect. Sec Core Plug Replacement in this chapter. Check oil lind coo lant passages for sludge, dirt and corro- sion while cleaning. If the passages are very dirty , have the block boi led out by a machine shop. Blowout all pas- sages with compressed air. Che ck the threads in the head bolt holes to make sure they arc clean. lf'dirty. use a tap to restore the threads and r emo ve any depo sits. Bore g auge 2. Examine the bloc k f or cracks To confirm suspicions abou t possible leakage areas.
use a mixtu re of one part kerosene and tv..o parts engine oil. Coat the suspected area with this solution. then wipe dry and immediately apply a solution of zinc oxide disso lved in wood alcohol. If any discoloration appears in the treated area. the block is cracked and should be replaced. 3. Check the flatness of the cylinder block deck or top surface. Place an accurate straightedge on the block. If there is any gap between the block and straightedge, mea- sure it with a flat feeler gauge ( I- "igurc 86). Measure from end to end and from come r to c om er. Have the block re- su rf aced if it is warped mor e than 0.07 mm (0.0028 in.). 4.
Measure the cyl inder bore with a bore gauge (Fig ure 87) for out-of-rou ndness or excessive wear as described in Piston/Cylinder Bore Check in this chapter. If the cylin- der ex ceed s maximum tolerances. r cbor e the cylinder. Rcbore the cylinder if the cy linder walls are badly scuffed, scored or other wise damag e. the mea surement with the specification in T abl e I. If gear back lash is incorrect, replace the cam sha ft and crankshaft gears. CYLIl'IDER BLO CK Core 1)11l~ Replacem ent Cleaning and Inspection Check the condition of the front (Figure HH ) and rear (f igure H9)core plugs in the block whenever the engine is out of the boat for ser vice.
If any signs of leakage or corro- sion arc found around one core plug. replace both of them . I. Clean the block thoroughly with solvent. Remove any gasket or RTV sealant residue from the machined sur-